Lincoln Electric COMMANDER 500 IM644-A - Manual (Page 49)

F-13 DIAGRAMS F-13
COMMANDER 500
CONNECTION DIAGRAM:
Do not operate with panels open. before servicing. Disconnect NEGATIVE (-) BATTERY LEAD Do not touch electrically live parts.
PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION. APPLICATIONS. SEE OPERATING MANUAL.
CAUTION : THE ENGINE WELDER OPERATING MANUAL.
N.C. REQUIRES OPTIONAL K1597-1 42VAC TRANSFORMER KIT.
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
Keep guards in place. Keep away from moving parts.
WARNING
Only qualified personnel should install,use or service this equipment.
TO LN-742 INPUT
COMMANDER / LN-742 CONNECTION DIAGRAM
K592 CONTROL CABLE
N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE SELECTOR SWITCH TO "WIRE WELDING CV".
CABLE PLUG
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
A
S24609
ELECTRODE
TO WORK
14 PIN AMPHENOL
ELECTRODE CABLE
TO WORK
TO WIRE FEED UNIT