Lincoln Electric EAGLE SVM192-A - Manual (Page 53)

ROTOR RESISTANCE TEST (continued)
13. Measure the resistance to ground.
A. Set the ohmmeter on the high scale
(X100,000).
B. Place one probe on either of the slip rings.
Place the other probe on any good,
unpainted ground. The machine ground
stud works well.
C. Check the resistance. It should read very
high, at least 0.5 megohm (500,000
ohms).
If the test does not meet the resistance speci-
fications, then the rotor may be faulty. Replace
the rotor.
If the test does meet the resistance specifica-
tions, then the rotor is okay.
14. Connect lead 200A to the positive brush, which
is the one nearest the rotor lamination.
Connect lead 219 to the negative brush.
15. Reinstall the case side, case top, fuel cap, lift
bail gasket and spark plug wires.
TROUBLESHOOTING AND REPAIR F-17 F-17
EAGLE™ 10,000
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC