Lincoln Electric EAGLE SVM192-A - Manual (Page 77)

Be sure to follow the recommended static-free
methods for handling printed circuit boards.
Failure to do so can result in permanent damage to
the equipment.
12. With a Phillips head screw driver, remove four
self tapping screws holding the printed circuit
board.
13. Replace the old printed circuit board with a
new one.
14. Connect the 12-pin molex plug.
15. Connect the 4-pin molex plug.
16. Connect two 1/4” Q.C. wires to P.C. Board.
17. Replace any cable ties that were cut during
the removal procedure.
18. Replace 4 self tapping screws previously
removed.
19. Reinstall the case side, fuel cap, lift bail gas-
ket, case top, and spark plug wires.
TROUBLESHOOTING AND REPAIR F-41 F-41
EAGLE™ 10,000
PRINTED CIRCUIT BOARD REMOVAL
AND REPLACEMENT (continued)
CAUTION
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC