Lincoln Electric EAGLE SVM192-A - Manual (Page 88)

TROUBLESHOOTING AND REPAIR F-52 F-52
EAGLE™ 10,000
RETEST AFTER REPAIR
Retest a machine:
• If it is rejected under test for any reason that requires you to remove any mechanical part which could affect the
machine’s electrical characteristics.
OR
• If you repair or replace any electrical components.
ENGINE OUTPUT
Mode No Load RPM Load RPM
Low Idle 2150-2250 NA
High Idle 3700-3750 3100-3600
WELDER DC OUTPUT 1
Output Control Range Switch Open Circuit Load Volts Load Amps
Volts
Maximum Maximum 65 - 72 21 - 26.5 205 - 240
AUXILIARY POWER RECEPTACLE OUTPUT 1
230 Volt Receptacle 115 Volt Receptacle 2
Open Circuit Load Volts Load Amps Open Circuit Load Volts Load Amps
Voltage Voltage
246 - 264 216 - 250 34 - 41.5 123- 132 114 - 126 35 - 42
FIELD AMPS AND VOLTS
Slip Ring Volts Field Amps
28.0 - 46.0 VDC 6.5 - 7.5 VDC
1 OUTPUT CONTROL switch set at MAXIMUM (position 10).
2 Output values of each receptacle can vary within the range shown but must be within 2 volts of each other.
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC