Lindy Carbon Monoxide Alarm - Manual (Page 17)

1 Reset
Resets the RMS to a defined
standard state (> 5).
2 LED
"Fault" (red) lights, up in connection
with reset,overload or a serious sys-
tem fault. “Warning“ (yellow) lights
up if the conditions of an appropriately
configured filter apply (> 4.9), when
booting and in connection with Reset.
“Power“ (green) lights up when the
device is supplied with voltage.
9 “COM” communication socket
for connection to a PC or
terminal (serial communication
cable included).
Never connect both COM interfaces at the same time!
In the initial state, various status messages are displayed cyclically in the
LCD display. Each message is displayed for approximately 2 seconds.
Device name
SNMP Information (> 4.5.1)
– Name (N)
– Location (L)
– Contact (C)
Network Information (> 4.5)
– IP Address (I)
– Netmask (N)
– Broadcast Address (B)
– Gateway Address (G)
O
PERATION O
PERATION
4
17
Monitoring System
Rack Monitoring System
4.1
4.2
OPERATOR CONTROL ELEMENTS
Note
INITIAL STATE
3 Illuminated LCD display. Plain
text display of inputs, messages
and alarms.
4 Contrast controller for the LCD display
5 Left key
Page back in the menu, reduce
values
6 Right key
Page forward in the menu,
increase values
7 MENU key
Change to menu level
8 ENTER key
Menu selection of confirm
values
LINDY RMS
N: RMS
L:Rechenzentrum
C: Fred Clever
I192.168.018.103
N255.255.255.000
B192.168.018.255
G192.168.018.200
RMS ADV. & RMS LITE RMS ADVANCED
1 2 3 4 5 6 7 8 9
1 2 9
RMS
ADVANCED
RMS LITE