Lindy Carbon Monoxide Alarm - Manual (Page 23)

O
PERATION O
PERATION
4
23
1
Monitoring System
Rack Monitoring System
4.5 Network Configuration
Note
Central input mask for settings
for the Ethernet interface.
References to sub-menus are
marked with “>”.
The Ethernet interface makes it possible to integrate the RMS into a local
network (10 Mbit Ethernet), thus making the following functions
available:
– SNMP support, thus integration into network management platforms
– Log book functional capabilities (syslog service)
– Loading and saving the system configuration (TFTP)
– Updating the system (TFTP)
• If the RMS is not operated in an Ethernet network, the settings descri-
bed in this chapter can be ignored.
If you are unclear about the conditions of the local network, please ask
your network administrator for assistance.
Incorrect settings can have the effect that the device is isolated from the
network and/or is no longer capable of sending messages to the desired
destination addresses (see also > 4.5.1).
[I] IP A DDRESS
IP address of the Ethernet interface.
[N] N ETMASK
Netmask of the Ethernet interface.
[B] B ROADCAST
Broadcast address of the Ethernet interface.
[G] G ATEWAY
Gateway to adjacent networks of the local network, which may be required.
[S] SNMP C ONFIGURATION
All SNMP-specific settings of the device (> 4.5.1).
[L] L OG S ERVICE
System log settings (> 4.5.2).
[?] H ELP
Explanation of the menu items..
[Q] Q UIT W ITHOUT S AVING
Jump back to the main menu without saving changes.
[R ETURN ] Q UIT W ITH S AVING
Jump back to the main menu and save changes.