Lindy Carbon Monoxide Alarm - Manual (Page 19)

19
Monitoring System
Rack Monitoring System
Filter messages
Display in the “Confirm“ menu
Entering network parameters
Filter messages are displayed on the LCD display as follows:
<Message number> (2-digit)
blank
<Time> (2-digit)
<Unit of time> (s; m = min; h; d)
Blank
<Filter-designation> (9-digit)
• Confirm filter messages with the ENTER key.
In the “Message Log” (> 4.10) the message is marked accordingly in
the “Ack” column with an “x”.
For the filter message to be displayed, it is necessary for the “Message
Priority” other than “none” to be assigned in the “Filter
Configuration” menu (> 4.9.2).
<Filter-Number> („F“; 2-digit; “:“)
* (only with confirmed filter)
<Current filter result > (3-digit: “off“ or “on“)
Blank
<Filter-designation> (9-digit)
For the display, it is necessary for “Confirmation” “yes” to be assigned
in the “Filter Configuration” menu (> 4.9.2). Otherwise, the message
"no confirm" appears.
If a connection via the COM interface is not possible, the following
four network parameters must be entered via the keys before the
device can be operated with Telnet:
– IP address
– Netmask
– Broadcast
– Gateway
If one of these menu items is selected in the LCD display, the first
position flashes after confirmation.
• Select the desired parameter with the arrow keys (the position
selected flashes) and confirm with the ENTER key.
• Change the value of the selected parameter using the arrow keys
(the parameter flashes) and confirm with the ENTER key.
Leave the numerical input:
• Select "OK" with the arrow keys and confirm with the ENTER key.
Enter
Enter
Enter
Enter
Enter
I192.168.018.103
IP: 192.168.018.103 OK
08 17
s
temperatu
F03:*off humidit
F03: no confirm