Lowrance electronic EP-60R - Manual (Page 13)

13
5. You will be taken back to the Bus Devices list, where the fuel flow
you selected (formerly Port FFlow) will be listed as Stbd FFlow. If the
newly configured fuel flow is not shown, refresh the Bus Devices list.
Reset
The Reset command in the Fuel Flow level menu will clear the sensor’s
configuration and calibration settings.
NOTE:
After using the Reset command, you will have to re-enter your
engine-tank configuration. It, however, will not affect the
configuration or calibration of other devices on the network.
To reset fuel flow settings:
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
MENU
.
2. Highlight
B. D
EVICES
and press
MENU
. After a few moments, the Bus
Devices list will appear.
3. Select the desired fuel flow and press
MENU
. Highlight
R
ESET
, press
MENU
and the following message will appear: Hit Menu to Rst Values.
4. Press
MENU
to reset fuel flow values to default settings.
EP-60R Fuel Flow Calibration
The factory calibration settings for the EP-60R Fuel Flow should be
within 3 percent, so calibration will not be necessary in most cases.
NOTE:
Make sure the fuel flow has been set as the Fuel Remaining Source;
otherwise, you will not be able to calibrate the fuel flow.
Fuel Flow Accuracy
To check fuel flow accuracy, you must add the Fuel Manager page to
the page screen rotation and then customize it with Fuel Used data.
To add Fuel Manager page to the display:
1. Press
MENU
, use the
UP
and
DOWN
keys to select
P
AGES
and press
MENU
, which will open the Pages menu with the following options: Add
Page, Rem Page, Autoscroll and Set Pop-up.
2.
Select
A
DD
P
AGE
and press
MENU
.
3. Highlight
F
UEL
M
ANAGER
(Fuel Mngr) and press
MENU
. You will be
taken back to the main display.
NOTE:
Make sure the Fuel Remaining Source has been set to Fuel Flow.