Lowrance electronic EP-60R - Manual (Page 38)

38
5. Highlight the device and press
ENTER
. The Device Configuration
menu will open. The device name will be reset to its default setting.
Press
EXIT
repeatedly to return to the main display.
Location
The Location menu allows you to select a configuration name that
matches the location of the engine connected to your fuel flow sensor.
To change fuel flow location:
1. Press
MENU
twice, select
NMEA 2000
or
N
ETWORKING
and press
ENTER
. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
B
US
S
ETUP
and press
ENTER
, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the fuel flow you want to configure and press
ENTER
. The
Device Configuration menu will appear.
4. Select
L
OCATION
and press
ENTER
, which will open the Location menu.
NOTE:
If you want to unconfigure your fuel flow, select
U
NKNOWN
from the
Location menu.
5. Highlight the desired location and press
ENTER
. The following
message will appear: Are you sure you wish to change this device's
configuration?
6. Select
Y
ES
and press
ENTER
. Press
EXIT
repeatedly to get back to the
main display.
Unconfiguring an EP-60R Fuel Flow
You can unconfigure a fuel flow by manually resetting its Location to
default settings (Unknown) via the Location menu or you can use the
Restore Defaults command.
To reset the fuel flow's device name, refer to the previous segment
covering Device Name. The Device Name also may be reset by using
the Restore Defaults command.
NOTE:
If you execute the Restore Defaults command, you will have to re-
enter your engine-tank configuration settings. The Restore
Defaults command is covered at the end of this section.