Lowrance electronic EP-60R - Manual (Page 23)

23
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
.
2. Highlight
B
US
D
EVICES
and press
ENTER
. The Bus Devices list will
appear.
Bus Devices highlighted in the System Setup menu (left). Searching
Bus Devices window (center) with Bus Devices list (right).
3. Select
U
N
C
FG
F F
LOW
and press
ENTER
. The following message will
appear: Press Enter to Configure Fuel Flow Snsr.
4. Press
ENTER
. If your unit is configured for more than one tank, the
Select Engine menu will appear. (If your unit is set to a single-tank
configuration, the Select Engine menu will not appear. The fuel flow
will automatically be given the configuration name Eng FFlow.)
5. Select the desired engine and press
ENTER
. You will be directed to
the Bus Devices list. Press
EXIT
repeatedly to return to the main
display.
To unconfigure a fuel flow:
You will use the Unset Engine command to unconfigure a fuel flow.
To unset engine:
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
.
2. Highlight
B
US
D
EVICES
and press
ENTER
to open the Bus Devices list.
3. Select the desired fuel flow and press
ENTER
. The Fuel Flow menu
will appear. Select
U
NSET
E
NGINE
and press
ENTER
. The following
message will appear: Press Enter to UnConfig Device Name
.
4. Press
ENTER
and you will be directed back to the Bus Devices list,
where the fuel flow you unconfigured will be shown as UnCfg F Flow.
To reconfigure a fuel flow:
You will use the Change Engine command to reconfigure a Fuel Flow.
Change Engine, however, will only appear on the LMF-400 menu if a
multiple engine setting was chosen during Boat Setup. If all the fuel
flows on your vessel are configured, you will have to unconfigure a fuel