Lowrance electronic EP-60R - Manual (Page 33)

33
Display Unit: EP-60R
Configuration & Calibration
All NMEA 2000 capable Lowrance sonar and sonar/GPS combo display
units can be used to configure and calibrate your EP-60R Fuel Flow
sensor on a NMEA 2000 network.
The LMS-525cDF is one of many Lowrance display units that may be
used to configure an EP-60R Fuel Flow sensor.
NOTE:
Your unit may have NMEA 2000 menu or a Networking menu,
depending on your display unit's software version. Both menus
allow you to perform the same NMEA 2000 related functions.
Bus Setup
Selecting Bus Setup from the NMEA 2000 or Networking menu will
open the Bus Configuration menu, giving you access to the Engine-
Tank Configuration menu and the NMEA 2000 Devices list.
The list, located in the top half of the Bus Configuration menu, shows
all devices connected to the network. The Engine-Tank Configuration
menu is located in the bottom half of the Bus Configuration menu. The
network devices list is located in the top half of the Bus Configuration
menu.