LOREX Technology LH330 EDGE2 - Manual (Page 128)

110
Appendix C: Connecting PTZ Cameras
Creating PTZ Presets
1 Adjust the camera position and zoom as needed.
2 Click SET. The presets available turn blue.
3 Click the number of an available preset to save the camera position to that preset.
Loading PTZ Presets
• Click the number of the preset you would like the camera to go to.
Deleting PTZ Presets
• Click CLEAR then click the number of the preset you would like to delete.
Using Preset Auto-Sequence
When Preset Auto-Sequence is activated, the camera will cycle through all created presets
in numerical order. For example, the camera will go from Preset 1, to Preset 2, and
continue in order until it reaches the last saved preset, at which point it will return to
Preset 1.
The camera will pause for a few seconds in between each preset, depending on the Time
setting.
To start Preset Auto-Sequence:
1 Create some presets using the steps above.
2 Adjust the Time bar. The further to the right the cursor is, the longer presets will be shown
before changing.
3 Click Auto SEQ to start Preset Auto-Sequence. The camera will begin moving between preset
positions. Once Preset Auto-Sequence is started, you may click X to exit the PTZ controls, and
the camera will continue to move automatically.
Adjust the time presets are
shown before switching Start/stop Preset
Auto SEQ
NOTE: Preset Auto-Sequence will stop if you use any of the manual PTZ controls.
4 Click Auto SEQ again to stop Preset Auto-Sequence.