LOREX Technology LH330 EDGE2 - Manual (Page 60)

42
Using the Main Menu
Step 1 of 3: Enable Motion Detection on
your cameras:
1 While viewing, click to open the Main
Menu.
2 Click to open the Alarm Menu.
3 Under cameras that you wish to enable for
motion detection, click Motion Enable and
select O.
4 Right-click to save your changes and
return to the Main Menu.
Step 2 of 3: Configure the Motion Alarm
Schedule for 24/7 motion recording:
1 From the Main Menu, click to open
the Alarm Menu.
2 Click Alarm Setup>Motion Alarm
Schedule to open the Motion Alarm
Schedule.
3 Configure the Motion Alarm Schedule to
enable motion events at all times. The
schedule will be solid yellow when motion
events have been enabled on a 24/7 basis.
NOTE: Use the range selectors below
the Motion Alarm Schedule to
configure multiple boxes at a
time.
4 Right-click until you have returned to the
Main Menu to save your changes.
Step 3 of 3: Disable Continuous
Recording (Working and Non-working
Hours):
1 From the Main Menu, click to open
the Record Menu.
2 Click Video Frame Rate. The Video Frame
Rate Menu opens.
3 Set both the Working Rate and
Non-working Rate to 0 for cameras that
you want to configure for motion recording
only. This disables continuous recording on
these cameras.
Set the Working Rate and Non-working rate to 0 to
disable continuous recording
NOTE: Ensure that the Alarm/Motion
Rate is higher than 0 on cameras
that you want to configure for
motion recording only.
4 Right-click repeatedly to save your
changes.
Configuring Motion Detection Areas
and Sensitivity
You can configure the DVR to detect
motion only in certain areas. This can be
helpful if you want to only detect motion
in an important area (for example, the
entrance or driveway of your house) or if
normal traffic or movement (for
example, from a public street or a tree)
in an area is triggering the motion
detection.
You can also adjust the motion detection
to be more or less sensitive. Higher
motion detection sensitivity means that
smaller amounts of motion will trigger
motion events. Lower motion detection
sensitivity means that it will take more
motion to trigger a motion event.
To configure motion detection areas
and sensitivity:
1 From the Alarm Menu, select Motion
Setup.