LOREX Technology LH330 EDGE2 - Manual (Page 36)

18
On-screen Display
To re-assign camera positions using
a touch screen monitor:
1 Press and hold your finger on the
channel you want to re-assign.
• A camera menu appears.
NOTE: Tapping on the screen may
cause the DVR to switch to
Single-Channel / Full-Screen
mode. If it does this, press the
button to return to
Split-Screen view.
2 Move your finger from left to right to change the channel. Release your finger when the
desired camera is highlighted to select it.
Using Sequence View
In Sequence view, the DVR automatically switches between camera channels every few
seconds (for instructions on changing the amount of time channels are shown before
switching, see “Changing the Sequence Dwell Time” on page 32). The following modes are
available for Sequence view:
• Single-channel Sequence: The DVR
automatically switches between connected
cameras in full-screen.
Sequence Mode Selector
Single-channel Sequence 4-way Sequence
• 4-way Sequence: The DVR switches between
every channel, showing 4 channels at a time.
To enter / exit Sequence view:
• Click to enter Sequence view. Sequence
view uses the last mode selected.
• Click to exit Sequence view and return
to Split-Screen mode.
To change the Sequence mode:
1 Click while viewing in Sequence view. The Sequence Mode Selector appears.
2 Click to select 4-way Sequence or for Single-channel Sequence.