LOREX Technology LH330 EDGE2 - Manual (Page 27)

9
Getting Started
Connecting Cameras
ATTENTION : Cameras differ in terms of installation or mounting instructions. Please see
the documentation that came with your camera(s) for specific installation instructions.
Test the cameras before permanent installation. Plan where you will route the wiring for
the camera and where you will aim the camera.
Installation Tips
• Mount the camera where the lens is away from direct and intense sunlight.
• Plan your cable wiring so that it does not interfere with power lines or telephone lines.
• Ensure that the camera wiring is not exposed or easily cut.
• Mount the camera in an area that is visible, but out of reach.
• Avoid pointing the camera at a glass window to see outside, as this may result in a poor image
caused by glare from indoor / outdoor lighting conditions.
• Adjust the camera angle so that it covers an area with high traffic.
• In "high-risk" locations, have multiple cameras point in the same area. This provides camera
redundancy if a vandal attempts to damage the camera.
Installing Cameras
1 Mount the camera(s) to the desired mounting surface according to the instructions that came
with the camera(s). Choose a firm mounting surface.
NOTE: If you wish to mount cameras to drywall, it is recommended to use drywall plugs
(not included).
2 Adjust the camera stand to ensure that the camera has a satisfactory view of the area you
would like to monitor. Stand configuration depends on the mounting surface you have chosen
(see below for suggested stand configurations).
Table Mount Wall Mount Ceiling Mount
Camera model not be exactly as shown.
NOTE: There are two connection points for certain cameras. Secure the stand to the top
thread for wall mounts or ceiling mounts. Secure the stand to the bottom thread
for table mounts or wall mounts.
Top thread
(Ceiling mount, Wall mount)
Bottom thread
(Table mount)
Secure to camera
thread
Camera model may not be exactly as shown.