LOREX Technology LH330 EDGE2 - Manual (Page 28)

10
Getting Started
Connecting BNC Cameras to your DVR
1 Connect the male power connector on the BNC extension cable to the female power
connector on the camera.
• Connect the BNC connector to the camera.
2 Connect the female power connector on the BNC extension cable to the power adapter.
3 (8-channel) Connect the BNC connector to one of the Video In ports on the rear panel of the
DVR.
• (16-channel) Connect the Octopus BNC connector for channels 1-8 (included) to the Video
IN CH 1~8 port and the Octopus BNC connector for channels 9-16 (included) to the Video IN
CH9~16 port on the rear panel of the DVR. Connect the BNC cameras to the Octopus BNC
connector(s). The label at the end of each connector indicates the channel number.
4
BNC Extension cable
Female power connector
Digital Video Recorder
(8-channel model shown)
Male power connector
Plug the power adapter to a power outlet.
Connecting and Removing BNC Cables
BNC (Bayonet Nut Connector) is a special connector that locks on to the system port and
cannot be accidently removed.
To connect or remove a BNC connector:
• Push the BNC connector firmly into the BNC port and simultaneously twist the connector
clockwise to tighten.
• To remove a BNC connector from a BNC port, push and simultaneously twist the connector
counter-clockwise to loosen the BNC connector.