Resetting the dvr to factory default settings, Loading a system configuration from a usb drive – LOREX Technology LH330 EDGE2 User Manual

Page 52

Advertising
background image

34

Using the Main Menu

3

Click Video-Out Setup. The Video-Out
Setup Menu opens.

4

Click HDMI Screen Size, and scroll up /
down to adjust the screen size.

Click HDMI Screen Size and scroll up / down to adjust
the screen size

NOTE: Adjusting the HDMI Screen Size

setting has no effect if the
monitor is connected with a VGA
cable.

5

Right-click until you have exited all menus
to save changes.

Resetting the DVR to Factory

Default Settings

ATTENTION

: Resetting to Factory Default

Settings will not erase your recordings,
but it will erase all event and playback
markers in the Event List.

This cannot

be undone.

1

From the Setup Menu, click Config Setup.

2

Click Load Factory Default.

3

Click Yes to confirm or No to cancel.

Please allow a few moments for the
system to reset.

Saving your System Configuration

to a USB Flash Drive

You can save your current system
configuration to a USB flash drive (not
included). This allows you to save all of
your current settings for backup
purposes.

NOTE: This function only saves settings

created in system menus. It

does not save or backup any
video.

To save your system configuration to a
USB flash drive:

1

Connect a USB flash drive (not included) to
one of the USB ports.

2

Format the USB flash drive with the DVR if
you have not done so already. For
instructions, see “Formatting the USB
Drive” on page 43.

3

From the Setup Menu, click Config Setup.

4

Click Save Config to USB and then click
Yes to confirm.

Click to save DVR configuration to a
USB flash drive (not included)

5

Wait until the save is completed.

Loading a System Configuration

from a USB Drive

1

Insert a USB flash drive (not included) with
a saved configuration file into one of the
USB ports.

2

From the Setup Menu, click Config Setup.

3

Click Load Config from USB and then click
Yes to confirm.

4

Wait for the system to finish restoring the
configuration. Do not pull the power plug
or power off the DVR during while the
configuration is restored.
The DVR will
restart once it is finished.

Advertising
This manual is related to the following products: