Landmark Lighting D20R2-06/99 - Manual (Page 14)

k. Select Option 1, File/DB Activity, to display the TMON for
CICS File/DB Activity Selection Menu.
l. Tab to the SUMMARIZE BY field, overtype the “1” with a “2”
and press ENTER. The TMON for CICS File/DB Activity
screen is displayed.
m. Cursor-select any active volume listed in the VOLSER
column to display the Device Detail Selection Menu. The
following message appears on the screen.
TMVS18879I - I/O PROFILE SUCCESSFULLY STARTED
Press ENTER.
Wait approximately two minutes before proceeding to the next
step unless the following message appears on the screen.
TMVS09701I I/O PROFILE COMPLETED. TYPE =5.1 TO ACCESS PROFILE MENU
n. Enter =5.1 on the command line to display the TMON for
MVS Profile Status/Selection screen.
o. Cursor-select the completed I/O profile to display the I/O
Profile screen.
p. Enter KEEP on the command line. The following message
appears on the screen.
TMVS14002I - TRACE DATA IS NOW KEPT
q. Enter MAINMENU or = on the command line to display the
TMON for MVS Primary Menu.
r. Enter LOGOFF on the command line and press ENTER to
return to the TMON for CICS File/DB Activity Display
screen.
s. Enter LOGOFF on the command line and press ENTER to
return to the TMON for MVS Job Execution Monitor screen.
At this point, all connections to TMON for CICS should have been
terminated automatically with the reverse-video name of the
“current” monitor (bottom center of border) removed.
11. Verify the TMON for DB2 NaviGate connection .
a. Enter =1.3 on the command line to display the Job Execution
Monitor screen.
b. Tab twice to position the cursor at the DISPLAY field, and
enter D. The display of active tasks is reduced to show
only DB2 tasks.
c. Cursor-select any DB2 task to display the Job Detail Selection
Menu.
d. Select Option 11, NaviGate to CICS/DB2 Monitor, to display
the TMON for DB2 Primary Menu.
IVP Steps Chapter 1: Installation Verification Procedure
1-6