Landmark Lighting D20R2-06/99 - Manual (Page 77)

number
−
remote
−
users
×
number
−
remote
−
sessions
=
total
−
SLUs
You should define a minimum of 10 SLUs. A maximum of 999
SLUs can be defined.
For TMON for CICS, you need to define one applid for:
• Each group of CICS jobs on the Job Selection List screen from a
remote TMON for CICS
• Each pass-through session you expect to need
• Each remote TMON for CICS displayed by the Performance
Monitor
• Each Activity Monitor display of a transaction using
intersystem communication (ISC)
• Each concurrent attempt to cancel an interval control element
(ICE) or automatic initiate descriptor (AID) in CICS.
Note The number of SLUs you define should match the setting in the
SLUCOUNT startup parameter, which controls the number of
SLUs the Landmark PerformanceWorks MVS product attempts to
access at a given time.
You can specify the SLUCOUNT parameter in the startup
parameter member of your product. If you do not specify it, the
number of SLUs defaults to 123.
The following table indicates the SLUCOUNT startup parameter
for each Landmark PerformanceWorks MVS product.
Product Description
TMON for CICS/ESA Specify the SLUCOUNT startup
parameter in member TCEPARM of the
data set identified by ddname
TMONPRMS in the TMON for CICS/ESA
startup JCL.
TMON for CICS/MVS Specify the SLUCOUNT startup
parameter in member TMON8PRM of the
data set identified by ddname
TMONPRMS in the TMON for CICS/MVS
startup JCL.
TMON for DB2 Specify the SLUCOUNT startup
parameter in member TDBPARM of the
data set identified by ddname
TMDBPRMS in the TMON for DB2 startup
JCL.
TMON for DBCTL Specify the SLUCOUNT startup
parameter in member TDBCPRMS of the
data set identified by ddname
TDBCPRMS in the TMON for DBCTL
startup JCL.
Chapter 3: Landmark Product Communication Setting Up Landmark Product Communication
The Monitor for MVS 2.0 3-5
System Administrator’s Guide