Lexmark 5300 Series - Manual (Page 137)

Windows XP users only
1 Click Start ΠSettings ΠPrinters and Faxes.
2 Make sure:
• The printer icon does not say Paused. If the printer is paused, right-click the icon, and then click Resume
Printing.
• The printer icon says Ready. If it says Offline, right-click the icon, and then click Use Printer Online.
• The printer icon has a check mark indicating that the printer is set as the default printer. If it is not, right-click
the icon, and then click Set as Default.
Windows 2000 users only
1 Click Start ΠSettings ΠPrinters.
2 Right-click the Lexmark 5300 Series icon.
3 Make sure:
• Set as Default Printer is selected.
• Pause Printing is not selected.
• Use Printer Offline is not selected.
Settings are not saved
These are possible solutions. Try one or more of the following:
C
HANGE TIME
-
OUT SETTINGS
If you press to select a setting, an * appears next to the selected setting. The printer reverts to the default setting
after two minutes of inactivity or if the printer is turned off.
S
AVE SETTINGS
If you press to select a setting, an * appears next to the selected setting.
Checking printer readiness
The printer may not be ready to print. Check the following. When you think you have solved the problem, test the
solution by sending a document to print.
D
OES THE PRINTER HAVE PAPER
,
AND IS IT PROPERLY LOADED
?
For more information, see “Loading paper”.
A
RE THE STICKER AND TAPE REMOVED FROM THE PRINT CARTRIDGES
?
1 Lift the scanner unit.
2 Remove the print cartridges from the print cartridge carrier.
3 Make sure the sticker and tape are removed from the bottom and back of the cartridges.
Troubleshooting
137