Lexmark 5300 Series - Manual (Page 146)

Cannot print from digital camera using PictBridge
These are possible solutions. Try one or more of the following:
E
NABLE
P
ICT
B
RIDGE PRINTING FROM CAMERA
Enable PictBridge printing on the camera by selecting the correct USB mode. For more information, see the digital
camera documentation.
M
AKE SURE THE CAMERA IS A
P
ICT
B
RIDGE
-
ENABLED DIGITAL CAMERA
1 Disconnect the camera.
2 Connect a PictBridge-enabled digital camera to the PictBridge port. See the digital camera documentation to
determine whether it is PictBridge-enabled.
C
HECK
USB
CABLE
Use only the USB cable that came with the camera.
R
EMOVE MEMORY CARDS
Remove any memory cards from the printer.
C
HECK MESSAGES
If an error message appears on the display, see “Error messages on the computer screen” on page 169.
Partial 4 x 6 in. (10 x 15 cm) photo prints when using a
PictBridge-enabled digital camera
M
AKE SURE PHOTO SIZE AND PAPER SIZE ARE SET CORRECTLY
The printer displays the Paper/Photo Size Error when your chosen photo size does not match the paper
size that is set. This typically happens when you are trying to print from your PictBridge-enabled digital camera.
You may have left the printer control panel Photo Size menu item setting at 8.5 x 11 in. or 5 x 7 in. size,
but your camera has a print size of 4 x 6 in. or L. You need to make sure your chosen photo size on the printer
is 4 x 6 in. or 10 x 15 cm, depending on the typically used photo size for your country or region.
• Make sure the 4 x 6 in. (10 x 15 cm) photo paper is loaded correctly in the paper support.
• If your camera lets you change the print size setting, change the print size selection to 4 x 6 in. (10 x 15 cm) on
the PictBridge-enabled digital camera.
• If your camera does not allow you to change the paper size setting, use the control panel to change the paper
size to 4 x 6 in. (10 x 15 cm).
1 Insert the USB cable that came with your camera to the camera, and insert the other end into the PictBridge
port on the front of the printer.
2 Turn the camera on, and choose your first photo using the camera control panel.
3 Wait for PictBridge Printing to appear on the display of the printer control panel.
Note: If Paper/Photo Size Error appears, press to clear the error message.
Troubleshooting
146