Lantronix XPress DR+ - Manual (Page 32)

Chapter 4: XPress DR+W
XPress DR+ User Guide 32
LEDs
Table 4-1. XPress DR+W LED Functions
LED Status Meaning
Off No data being transmitted from XPress DR+ Serial port - TXD LED (Yellow)
Blinking Data being transmitted from XPress DR+
Off No data being received by XPress DR+ Serial port - RXD LED (Green)
Blinking Data being received by XPress DR+
Off No Ethernet link established. Ethernet port - 10/100 Link (Green)
Steady On Ethernet link established.
Off No data activity Ethernet port – Activity (Yellow)
Blinking Data activity
Steady On Power OK
Blinking 2x No DHCP response
Power/Diagnostic LED (Orange)
Blinking 2x
Setup Menu active
Off Wireless off (not configured for wireless)
Off Wireless on, searching
Blinking (very short) Wireless on, attempting to associate
On Wireless on, associated, power management off
Wireless LED (Yellow)
On when receiving or
transmitting, off in-between Wireless on, associated, power management on
Required Information for Initial Configuration
Hardware Address
Take note of the unit’s hardware address (also known as MAC address). It is on
the product label, in the format: 00-20-4a-XX-XX-XX, where the XXs are unique
numbers assigned to the product.
Hardware Address : 00-20-4a-_____-_____-_____
IP Address
The XPress DR+W must have a unique IP address on the network. The systems
administrator generally provides the IP address, subnet mask, and gateway.