Lantronix XPress DR+ - Manual (Page 48)

Chapter 6: Configuration Using Web Manager
XPress DR+ User Guide 48
Note: Disabling BOOTP, DHCP, and AutoIP (all three checkboxes) is not
advised as the only available IP assignment method will then be ARP or the
serial port.
5. When finished, click the OK button.
6. To save and reboot, click Apply Settings on the main menu.
Static IP Address Configuration
You manually assign an IP address to the unit and enter related network settings.
To assign an IP address manually:
1. On the main menu, click Network.
2. (Wireless units only) From the Network Mode drop-down list, select Wired Only or
Wireless Only to set the unit for wired or wireless use.
3. Select Use the following IP configuration.
4. Enter the following (as necessary):
IP Address Enter the IP address manually in decimal-dot notation. The IP
address must be set to a unique value in the network.
Subnet Mask A subnet mask defines the number of bits taken from the IP
address that are assigned for the host part.
Default Gateway The gateway address, or router, allows communication to
other LAN segments. The gateway address should be the
IP address of the router connected to the same LAN segment
as the unit. The gateway address must be within the local
network.
5. When finished, click the OK button.
6. To save and reboot, click Apply Settings on the main menu.
Server Configuration
The unit’s server values display when you select Server from the main menu. The
following sections describe the configurable parameters on the Server Settings page.