Lantronix XPress DR+ - Manual (Page 84)

Chapter 9: Setup Mode: Channel Configuration
XPress DR+ User Guide 84
Point to many wireless devices at once is called multicast and uses the group
encryption method.
To receive broadcast and multicast messages, the group encryption for all
wireless devices communicating with the same access point must be equal. If
any of these devices is WEP-only (no support for WPA), set the encryption to
TKIP+WEP.
A group encryption lower than the pairwise encryption is necessary to use higher
security with the XPress DR+W than other devices connecting to the same
Access Point can support.
‹ CCMP is also called AES on products of other manufacturers. CCMP is an
extension of AES and is the correct term. It provides the strongest current encryption
method.
WEP
Authentication selects whether the encryption keys are matched (1 = shared) with those
of the communication partner before passing through messages or not (2 = open/none).
The Encryption prompt requests the length of the encryption key and the security
strength. WEP64 uses a 40 bits/5 bytes key (option 1). WPE128 uses a 104 bits/13 bytes
key (option 2).
Select Y (Yes) at the Display current key prompt to show the currently configured
key/passphrase.
Select Y (Yes) at the Change key prompt to be able to modify the currently configured
key.
The Key type indicates whether the new key is in hexadecimal or passphrase format.
Enter key prompts for the new encryption key.
Key Type Encryption Key
Hex Enter the Encryption Key as a hexadecimal value according the following
guidelines:
‹ Valid hex alphanumeric characters are 0-9 and A-F.
‹ 64 bit hex = 5 bytes represented as xx-xx-xx-xx-xx.
Example: 01-A3-47-E5-C9
‹ 128 bit hex = 13 bytes represented as xx-xx-xx-xx-xx-xx-xx-
xx-xx-xx-xx-xx-xx.
Example: A1-B2-C3-E4-D5-F6-98-74-B7-65-A8-D3-F2
Passphrase Enter the key as a string. A passphrase is a sentence that is translated into
hex by a hashing algorithm.
Example: My dog has spots and likes to chase cats.