Lantronix XPress DR+ - Manual (Page 88)

XPress DR+ User Guide 88
Chapter 10: Setup Mode: Advanced Settings
Expert Settings (Option 5)
Note: You can change these settings using Telnet or serial connections only, not
on the Web Manager.
Caution: Only a Network Administrator should change these parameters.
You must definitely know the consequences the changes might have.
Figure 10-1. Expert Settings
TCP Keepalive time in seconds
This option allows you to change how many seconds the unit waits during a silent
connection before attempting to see if the currently connected network device is still on
the network. If the unit gets no response, it drops that connection.
TCP Keepalive time in s (1s – 65s; 0s=disable): (45)? _
ARP Cache timeout in seconds
Whenever the unit communicates with another device on the network, it adds an entry
into its ARP table. The ARP Cache timeout option allows you to define how many
seconds (1-600) the unit will wait before timing out this table.
ARP Cache timeout in s (1s – 65s; 0s=disable): (600)? _
Disable Monitor Mode at bootup
This option allows you to disable all entries into Monitor Mode during startup, except for
the xxx sequence. This prevents entry using yyy, zzz, xx1, and yy1 key sequences (only
during the bootup sequence). The default setting for Monitor Mode at bootup is N (No).
(See
Chapter 12: Monitor Mode .)
Disable Monitor Mode @ bootup (N) ? _