Lantronix XPress DR+ - Manual (Page 69)

XPress DR+ User Guide 69
Chapter 9: Setup Mode: Channel Configuration
This chapter explains how to configure a serial port.
Notes:
‹ Current values display in parenthesis.
‹ You must enter some values in hexadecimal notation. (See Appendix D: Binary to
Hexadecimal Conversions).
Channel 1 (Option 1) and Channel 2 (Option 2)
Note: Channel 1 and Channel 2 have the same defaults except for the port number
(10001 for Channel 1 and 10002 for Channel 2).
Select Channel 1 (option 1) or Channel 2 (option 2) from the Change Setup menu to
define how the serial port responds to network and serial communications. The following
sections describe the configurable parameters within the Channel configuration menu.
Figure 9-1. Serial Port Parameters
Baudrate
The unit and attached serial device, such as a Programmable Logic Controller (PLC),
must agree on a speed or baud rate to use for the serial connection. Valid baud rates are
300, 600, 1200, 2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, and 230400
baud.
Baudrate (9600) ? _