Lantronix XPress DR+ - Manual (Page 39)

Chapter 4: XPress DR+W
XPress DR+ User Guide 39
Enter key prompts for the new passphrase or hexadecimal key.
Key Type Encryption Key
Hex Enter the Encryption Key as a hexadecimal value according the following
guidelines:
‹ Valid Hex alphanumeric characters are 0-9 and A-F.
‹ 64 bit hex = 5 bytes represented as xx-xx-xx-xx-xx.
Example: 01-A3-47-E5-C9
‹ 128 bit hex = 13 bytes represented as xx-xx-xx-xx-xx-xx-xx-
xx-xx-xx-xx-xx-xx.
Example: A1-B2-C3-E4-D5-F6-98-74-B7-65-A8-D3-F2
Passphrase Enter the key as a string. A passphrase is a sentence that is translated into
hex by a hashing algorithm.
Example: My dog has spots and likes to chase cats.
A passphrase of more than 20 characters is recommended. Maximum length
is 63 characters, including spaces and punctuation characters.
Passphrase input is not the same as ASCII input. The passphrase input is
safer because it has up to 63 characters. ASCII input has a maximum of 5
(WEP64) or 13 (WEP128) characters and limits the number of key
combinations.
Please refer to the other equipment’s manual to determine the passphrase
input style recommended.
Set the Encryption type to the minimum required security. The plus sign denotes that the
group (broadcast) encryption method is different from the pairwise (unicast) encryption, in
this case WEP and TKIP, respectively. For example, CCMP+TKIP => pairwise = CCMP,
and group = TKIP.
WPA2/802.11i
The WPA2/802.11i mode complies with the Robust Secure Network specified in the IEEE
standard 802.11i. It enables the AES-based strong CCMP encryption.
Enter key prompts for the new passphrase. Maximum length is 63 characters; the
recommended minimum is 20 characters.
Set the Encryption type to minimum required security. The plus sign denotes that the
group (broadcast) encryption method is different from the pairwise (unicast) encryption.
For example CCMP+TKIP => pairwise = CCMP, and group = TKIP.
Fixed or Automatic Data Rate
The XPress DR+W can control the transmission rate. Select 0 to set a fixed data rate, or
select 1 to set an automatic data rate. The default setting is 1 (auto).
TX Data rate 0=fixed, 1=auto (1) ? _