Liebert Cooling System XDV - Manual (Page 10)

General product information
4
3.3 Equipment Inspection
Upon arrival of the unit, and before unpacking, verify that the labeled equipment matches the bill of
lading. Carefully inspect all items for either visible or concealed damage. Damage should be immedi-
ately reported to the carrier and a damage claim filed with a copy sent to Liebert Corporation or to
your sales representative.
3.3.1 Recyclable Packaging
All material used to package this unit is recyclable. Please save for future use or
dispose of the material appropriately.
NOTICE
Risk of unit damage if improperly stored. Keep the unit indoors and protected from dampness,
freezing temperatures and contact damage.
NOTICE
Risk of damage from forklift. Improper handling with the forklift can cause exterior and/or
underside damage.
Keep tines of the forklift level and at a height suitable to fit below the skid.
Figure 4 Recommended unit handling equipment
!
CAUTION
Risk of sudden refrigerant discharge. Can cause loss of charge and minor injury.
If the optional pre-charged option is chosen, the Liebert XDV unit is shipped with a full
charge of R-134a refrigerant under pressure. Do not remove the pipe caps or plugs before the
unit is ready for connection to Liebert XD Piping.
Supply and return fittings on the pre-charged Liebert XDV units are one-shot connections. Do
not disconnect one-shot connections after they have been connected. Disconnection will
release pressurized R-134a refrigerant from the Liebert XDV.
!
WARNING
Risk of improper handling. Can cause equipment damage, injury or death.
Read all of the following instructions before attempting to move, lift, remove packaging from,
or preparing unit for installation.
!
CAUTION
Risk of sharp edges, splinters and exposed fasteners can cause injury.
Only properly trained personnel wearing appropriate safety headgear, gloves, shoes and
glasses should attempt to move, lift, remove packaging from, or prepare unit for installation.
R
Forklift
Pallet Jack