Precor C846 - Manual (Page 10)

page 10
C O M M E R C I A L P R O D U C T S D I V I S I O N
ADDITIONAL TOOLS NEEDED
Obtain the following tools before assembling the C846.
❑ ¾-inch box end wrench or crescent wrench
❑ Wire cutter
ASSEMBLY INSTRUCTIONS
Take the following steps to assemble the C846 Upright and C846 Recumbent Cycle.
Note: The C846 Upright and C846 Recumbent have similar assembly instructions
except for adjusting the seat.
1. Obtain assistance. Ask for assistance to help assemble the C846. Have the
assistant(s) place the shipping carton close to the location where you plan to use
the C846. Breakdown the sidewalls of the shipping carton so that they lie flat.
2. Remove the front and base assemblies. The front assembly is composed of
the upright support and display console. The base assembly is composed of
the base support, seat, pedals, and rear casing. Place the two assemblies
close to each other so that it will be easy to connect the cables and secure the
sections together. Refer to Diagram 2.
CAUTION: Do not assemble the C846 if it is plugged into its optional
battery recharger.
3. If necessary, unplug the C846 from its optional battery recharger.
4. Remove the two hex head cap screws (B) and two large washers (C) from
the hardware kit. Place a washer on each screw and set them aside.
5. Attach the upright support to the base assembly. Diagram 2. Before se-
curing the upright support to the base assembly, you need to add the rubber
bib, from the hardware kit, to the base of the upright support and attach the
upper and lower electronic cables. To do this, take the following steps:
a. Place the rubber bib on the base of the upright support as shown in Diagram 2, #1.
Diagram 2 Secure rubber bib and
attach upright console.
Upright support mounts
Cable connections
Upright support
2 1
2
Single cable
connection
C846 Upright Cycle
C846 Recumbent
Lip of rubber bib
Upright support
mounting bolt hole