Pioneer S-HTD330 - Manual (Page 79)

Additional information 12
79
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the system does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
General
Problem Remedy
The power does not turn on. • Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the system to shut off automatically.
No sound is output when a
function is selected. • If you’re using the line input, make sure the component is
connected correctly (see
Connecting auxiliary components on
page 77).
• Press
MUTE on the remote control to turn muting off.
• Adjust the VOLUME .
No image is output when
playing discs. • Make sure the TV is connected correctly (see Connecting to your TV
on page 16).
• Reset the video output to interlace (see
Connecting to your TV on
page 16
No sound from surround or
center speakers. • Refer to Setting the channel levels on page 62 to check the speaker
levels.
• Check that you haven’t selected the
STEREO sound mode (see
Listening in stereo on page 38).
• Check that the Virtual Advanced Surround mode is not on (see
Using the Advanced Surround effects on page 39).
• Connect the speakers properly (see Connecting the speakers on
page 13).
XV-HDT330_new.book 79 ページ ２００３年１月１６日 木曜日 午後４時１２分