Pioneer VSX-AX5Ai-G - Manual (Page 102)

Additional information 12
102
En
USB interface
Note
• If the unit does not operate normally due to external
effects such as static electricity, disconnect the
power plug from the outlet and insert again to return
to normal operating conditions.
Changing the frequency step
Multi-voltage model only
If you find that you cant tune into stations successfully,
the frequency step may not be suitable for your country/
region. Heres how to switch the setting:
1 Switch the receiver into standby.
2 While holding down the front panel TONE –
button, press the STANDBY/ON.
The display shows the new setting:
• STEP 9K/50K – For areas with an FM reception of
50kHz and AM reception of 9kHz
• STEP10K/100K – For areas with an FM reception of
100kHz and AM reception of 10kHz
Note
• If you’re unsure of the correct frequency step for your
region, consult your local Pioneer dealer.
Maintenance of external surfaces
• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• When the surfaces are dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six
times with water, and wrung out well, and then wipe
again with a dry cloth. Do not use furniture wax or
cleaners.
• Never use thinners, benzine, insecticide sprays or
other chemicals on or near this unit, since these will
corrode the surface.
PQLS ON This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
UNKNOWN When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Message Explanation
Symptom Cause Remedy
No sound. • The computer settings are incorrect. • Make sure you have set up your computer system to
output through the USB interface (see
Using the USB
interface on page 78).
• The software or source material you are
using is not compatible with USB output. • Update to a more recent version of your existing
software, try a different audio program, or try a different
source.
• The volume control on your computer is set
too low. • Turn up the volume on your computer.
VSX-AX5Ai.book 102 ページ ２００４年６月２日 水曜日 午後３時２７分