Pioneer VSX-AX5Ai-G - Manual (Page 3)

CAUTION
The
OFF ON and STANDBY/ON buttons on
this unit will not completely shut off all power from
the AC outlet. Since the power cord serves as the
main disconnect device for the unit, you will need to
unplug it from the AC outlet to shut down all power.
Therefore, make sure the unit has been installed so
that the power cord can be easily unplugged from
the AC outlet in case of an accident. To avoid fire
hazard, the power cord should also be unplugged
from the AC outlet when left unused for a long
period of time (for example, when on vacation).
D3-4-2-
2-2a_A_En
If the AC plug of this unit does not match the AC
outlet you want to use, the plug must be removed
and appropriate one fitted. Replacement and
mounting of an AC plug on the power supply cord of
this unit should be performed only by qualified
service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make
sure it is properly disposed of after removal.
The equipment should be disconnected by removing
the mains plug from the wall socket when left
unused for a long period of time (for example, when
on vacation).
D3-4-2-2-1a_A_En
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
D8-10-1-2_En
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate
the equipment.
D8-10-2_En
CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the
unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and
televisions, use shielded cables and connectors for connections.
D8-10-3a_En
TWO VOLTAGE SELECTORS
230-
240 V
120-127 V 110V
220 V
220V
230-240V 110V
120- 127V
Voltage selector
You can find the voltage selector switch on the rear
panel of multi-voltage models.
The factory setting for the voltage selector is 220V.
Please set it to the correct voltage for your country
or region.
• Saudi Arabia operates on 127V and 220V mains
voltage. Please set to the correct voltage before using.
• For Taiwan, please set to 110V before using.
• For Mexico, please set to 120-127V before using.
Before changing the voltage, disconnect the AC power
cord. Use a medium size screwdriver to change the
voltage selector switch.
D3-4-2-1-5_En
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long-term use for business purposes in a
restaurant or use in a car or ship) and which
requires repair will be charged for even during the
warranty period.
K041_En
Important information about this unit‘s
AC outlet (switched total 100W MAX)
Power supplied through these outlets is turned on
and off by this unit’s
OFF ON and
STANDBY/ON buttons. Total electrical power
consumption of connected equipment should not
exceed 100W.
CAUTION
•
Do not connect a TV set, monitor, heater or similar
appliance to this unit’s AC outlet.
• Do not connect appliances with high power
consumption to the AC outlet in order to avoid
overheating and fire risk. This can cause this unit
to malfunction.
D3-4-2-2-1b_A_En
VSX-AX5Ai.book 3 ページ ２００４年６月２日 水曜日 午後３時２７分