Panasonic WJ-HD100 - Manual (Page 21)

21
1. Move the cursor to STATUS POSI. with the [▲] or [▼]
button.
2. Select the desired position with the JogDial. The default
is R-LOWER.
L-UPPER: Displays the status in the left upper corner.
R-UPPER: Displays it in the right upper corner.
CENTER: Displays it in the center.
L-LOWER: Displays it in the left lower corner.
R-LOWER: Displays it in the right lower corner.
OFF: Status display is disabled.
● HDD FULL Selection
007 HDD FULL
Set the disk capacity from 1 % to 99 % to warn the operator
that the available capacity is nearing the end. There are two
warning levels. First the FULL indicator on the front panel
blinks when the remaining disk capacity has reached the
preset value. Finally the buzzer beeps when the disk is full,
provided that the DISK END BUZZER parameter in the REC
SETUP menu is set to ON. At the same time the FULL indi-
cator turns on.
1. Move the cursor to HDD FULL with the [▲] or [▼] but-
ton.
2. Select the desired value with the JogDial. The default
value is 1 %.
1 % to 99 %: The FULL indicator blinks when the
remaining disk capacity reaches the selected value.
DISPLAY SELECT
LCD CONTRAST
CLOCK
→
JAN 7.00 8:09
TIME&DATE TYPE1 24H
TIME&DATE DISP.ON
TIME&DATE POSI.R-LOWER
STATUS DISP. ON
STATUS POSI. R-LOWER
HDD FULL
1%
DISPLAY SELECT
LCD CONTRAST
■ SYSTEM SETUP
● Quick Play Mode Selection
101 FWD/REW MODE
Picture search is available in quick forward and backward
playback. Set the playback picture rate (FWD/REW MODE)
in the SYSTEM SETUP window to SKIP or SKIP&PLAY. The
playback sequence for each mode is shown below.
Data recorded
on the Disk
Image displayed
on the Monitor
Image displayed
on the Monitor
SKIP
Data recorded
on the Disk
SKIP&PLAY
Skip
Time
Expanded
Time
Time
Expanded
Time
Skip Play
1 Field Still Image
A Series of 32 Fields
SYSTEM SETUP
FWD/REW MODE SKIP&PLAY
PASSWORD LOCK OFF
ALL
→
*****
OPERATION
→
*****
KEYLOCK BUZZER OFF
RESET PULSE HIGH
TIME ADJUSTING SLAVE
SET TIME
→
9:00
AUTO ERASING OFF
1. Hold down the [SETUP/ESC] button for 2 seconds to
display the setup menu on the monitor.
2. Press the down [▼] button repeatedly until the SYSTEM
SETUP window appears. (You can switch through the
setup menus by repeatedly pressing the up [▲] or
down [▼] button.)
3. Move the cursor to FWD/REW MODE with the up [▲] or
down [▼] button.
4. Rotate the JogDial to select the desired parameter. The
default is SKIP&PLAY.
[SKIP]: One field still picture is picked up from the disk
and displayed on the monitor as shown above. This
is quicker than skip and play.
[SKIP&PLAY]: A 32-field series of pictures is played
back. We recommend that you select [SKIP &
PLAY] when a video multiplexer is installed in the
system.
DISPLAY SELECT
LCD CONTRAST
5. Press the [SETUP/ESC] button for 2 seconds to quit
setup.
CLOCK
→
JAN 7.00 8:09
TIME&DATE TYPE1 24H
TIME&DATE DISP.ON
TIME&DATE POSI.R-LOWER
STATUS DISP. ON
STATUS POSI.
R-LOWER
HDD FULL 1%