Printronix Integrated Network Interface Card - Manual (Page 238)

Chapter 12 Complete Command List
234
store tn dest <DXPRN> WSCSTname <WSCSTname>
Example: store tn dest d1prn WSCSTname *NONE
Store the queue name to which system messages will be
logged.
Default: *NONE
store tn dest <DXPRN> WSCSTlib <WSCSTlib>
Example: store tn dest d1prn WSCSTlib *LIBL
Store the queue library to which system messages will be
logged.
Default: *LIBL
store tn dest <DXPRN> [-]autoconnect
Example: store tn dest d1prn autoconnect
Store the state of the autoconnect flag. If the autoconnect flag
is enabled the NIC tn client will attempt a connection and
binding with the specified tn host automatically on power-up.
This connection sequence will be repeated every 60 seconds
until successful or the autoconnect flag is disabled.
See “tn dest <dxprn> start | stop” command.
Default: disabled
store tn dest <DXPRN> copytimeout
Example: store tn dest d1prn copytimeout 1000
Store the value of the copytimeout. When consecutive
TN5250/3270 jobs are sent to the NIC, they are treated
differently depending how soon they arrive. In an attempt to
provide a perception of collation when multiple copies are sent
from one host, if the time between jobs is less than the
copytimeout value then they are treated as copies and the job
is given precedence over other host documents. This keeps
documents, which are sent in rapid succession together as if
they were copies of the same document. A higher value
improves the likelihood of collation but impacts performance.
Default: 500