Printronix Integrated Network Interface Card - Manual (Page 249)

Set Commands
245
set sysinfo loginfo [-]sys | [-]tcp | [-]ipx | [-]spx
Example: set sysinfo loginfo -sys ipx
Set the NIC debugging information type. Usually this
information includes unexpected errors or exceptions from the
print server divided into these groups:
sys General system messages
tcp TCP stack messages
ipx IPX stack messages
spx SPX stack messages
NOTE: This is not printer or job logging information.
set sysinfo logport null|prn|syslog
Example: set sysinfo logport null
Define to where the debugging information should be sent. This
can be sent to an output device off of the NIC I/O port or to a
central TCP/IP host running a SYSLOG daemon. To set this
host, use the command
set sysinfo syslog
hostIPaddress .
set sysinfo smtp <IPaddress> [port <PORTNUM>]
Example: set sysinfo smtp 192.75.11.5 port 25
Define the SMTP (Simple Mail Transfer Protocol) server IP
address or domain name and port number where the mail is
stored on your network.
Default: Unconfigured, 25
set sysinfo email <EMAIL>
Example: set sysinfo email [email protected]
Define the user email address to receive printer and job logging
information from a particular logpath on the NIC. Email name is
the host or IP name of the user.
Default: Unconfigured
set sysinfo email emailname@domain
Example: set sysinfo email [email protected]
Define the user email address to receive printer and job logging
information from a particular logpath on the NIC.