Printronix Integrated Network Interface Card - Manual (Page 40)

Chapter 2 Configuration Tools
36
store ifc 2 wlan profile <WIFI-PROFILE> <0...6>
The values that can be set are as follows:
0: 802.11b operation only
1: mixed 802.11b and 802.11g operation
2: mixed 802.11b and 802.11g operation without support for 5.5
and 11 Mbps basic rates
3: 802.11g only operation
4: test 802.11g operation
5: 802.11b only operation without support for 5.5 and 11 Mbps
basic rates
6: mixed 802.11b and 802.11g operation with support for 5.5
and 11 Mbps basic rates
store ifc 2 wlan wpa <WPA-MODE>
store ifc 2 wlan cipher <WPA-CIPHER>
store ifc 2 wlan passphrase <WPA-PASSPHRASE>
store ifc <IFNUM> wlan country <COUNTRY-CODE>
Refer to page 219 for the complete command list.
HTML Forms
The NIC settings can be configured over TCP/IP through a
standard Web browser. The NIC Web pages provide a way to
access some of the commands built into the print server.
NOTE: If a router is used, make sure a Gateway value is
configured.
To access the NIC home page:
1. Make sure the print server has an IP address and Subnet Mask
so it is recognizable on your TCP/IP network.
2. Make sure your network station can successfully ping the NIC
over the network.
3. Direct your Web browser to the URL:
http://IPaddress
(e.g., http://192.75.11.9)
where IPaddress is the IP address of your NIC.