Pioneer Elite VSX-53TX - Manual (Page 11)

Easy Setup Guide Part 1
11
EA
SY
SE
TU
P
GU
ID
E
2 Speaker Connections
Home theater is designed to be setup with five, or seven speakers (front left and right; center; surround left and
right; and, optimally, surround back left and right) and a subwoofer, but you can use this receiver with fewer
speakers. Hook up the speakers you have to the A speaker terminals on the back of the receiver. If you only have two
speakers hook them up as FRONT. If you have three hook up the single speaker as CENTER. Follow the diagram
below in order to hook up all your speakers. A center speaker is very important for watching films because in digital
soundtracks the dialog comes from the center speaker. If you do not have a center speaker you must tell the receiver
the center channel is off or when you listen to digital soundtracks you won't hear any dialog. This can be done
automatically by following the “Auto Surround Sound Setup” instructions from page 13 in this Easy Setup Guide.
If possible, use surround back speakers. These speakers are important to take full advantage of all the sound
channels on new, eight channel home theater DVDs. The diagram below also explains how to hook up a subwoofer
which provides realistic bass sounds. For the subwoofer use a mono (single plug) RCA cord and for the other
speakers use regular speaker cords.
Make sure you connect the speaker on the right to the R terminal and the speaker on the left to the L terminal. Also
make sure the positive and negative (+/–) terminals on the receiver match those on the speakers.
Memo:
• We recommend speakers with a nominal impedance rated 8 Ω -16 Ω , but you can change the speaker
impedance setting of the receiver (see page 26).
• If you only have one surround back speaker hook it up to the left surround back terminal.
• If you use a THX certified subwoofer use the THX INPUT jack on the subwoofer (if your subwoofer has one) or
switch the filter position to THX on your subwoofer.
• When you attached your speaker wire to the speaker terminal make sure that not even one strand of wire touches
the back of the receiver. If this happens it could short out the receiver.
Powered
subwoofer Front
speaker
(Left)
Front
speaker
(Right)
Center
speaker
TV/monitor
Surround
speaker
(Right)
Surround
speaker
(Left)
Surround back
speaker (Right)
Surround back
speaker (Left)
3 Tighten
terminal.
 Speaker terminals
1 Twist exposed wire
strands together
tightly. 2 Loosen speaker terminal
and insert
The speaker terminals also
accept single banana plugs.
(Refer to speaker manual for
details.)
00_VSX-53TX.book Page 11 Monday, April 7, 2003 11:07 PM