Pioneer Elite VSX-53TX - Manual (Page 83)

Fine Tuning Your System
83
EX
P
E
RT
Function Rename
Use the FUNCTION RENAME capability to rename the display on the receiver and your OSD for different functions
(DVD, etc.). For example, you could rename VCR1/DVR as DVR-7000. For this particular setup using the controls on
the front panel is more convenient than using the remote control. Use the MULTI JOG dial instead of the

buttons and use the ENTER button on the front panel. You can also use the display on the front panel as opposed to
the OSD.
3-9 2
RETURN button
1 Turn on the receiver and your
TV. (If you want to use the
remote control for this setup,
press the RECEIVER button.)
2 Press the SET UP button.
This display appears on the receiver.
3 Looking at the display on your
receiver, use the MULTI JOG to
select FUNCTION RENAME.
Press the ENTER button.
4 Use the MULTI JOG to select
the name of the function (for
example, DVD/LD) you want to
change. Press ENTER.
Either the cursor underline bar or a character
(depending on which is selected) will blink.
The functions are divided into three different on-
screen displays so you may have to move
through them to find the function you want to
rename.
5 Use the MULTI JOG to cycle the cursor
through the letters, numbers and
symbols. Use the ENTER button to
enter one of the possibilities or move
forward a space.
The possible selections are shown below.
6 Repeat step 5 until you get the name
as you want it.
You can input up to ten characters.
7 Press ENTER repeatedly to exit the
name. The new function name is set.
8 Repeat steps 4-7 to change other
function names. Use the MULTI JOG
to select EXIT and press ENTER.
9 Use the MULTI JOG to select EXIT and
press ENTER.
This exits the SYSTEM SETUP mode and returns to
normal operation.
Memo:
Use the RETURN button to move the cursor back one
character when entering a name.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()*+,–./:;<=>?@[ \ ]ˆ_{|} [space]
00_VSX-53TX.book Page 83 Monday, April 7, 2003 11:07 PM