Pioneer Elite VSX-53TX - Manual (Page 82)

Fine Tuning Your System
82
Assigning the Component Video Inputs
This receiver has two component video inputs. Their default settings are video inputs for the DVD/LD (COMPONENT
VIDEO IN 1) and TV/SAT (COMPONENT VIDEO IN 2) functions, but you can reassign them if you want to use them
as video inputs for other receiver functions (for example a VCR).
See pages 16 and 17 for more on connecting equipment using component video cords.
1 Turn on the receiver and your TV,
press RECEIVER on the remote con-
trol.
2 Press the SYSTEM SETUP button.
3 Looking at the on-screen display on
your TV, use the  buttons to select
INPUT ASSIGN. Press the ENTER
button.
4 Use the  buttons to select
COMPONENT–IN SELECT then press
ENTER.
5 Use the  buttons to select the
component video input you want to
reassign. Press the ENTER button.
6 Use the  buttons to assign a
receiver function.
Choose between DVD/LD, TV/SAT, VCR1 and VCR2.
7 When you're finished use the 
buttons to select EXIT and press
ENTER.
You will leave the COMPONENT–IN SELECT mode.
8 Use the  buttons to select EXIT
and press ENTER. Then, use the 
buttons to select EXIT and press
ENTER again.
This exits the SYSTEM SETUP mode and returns to
normal operation.
Memo:
If you connect any source component to the receiver using a
component video input, you should also have your TV
connected to this receiver's component video output.
3
4
5
6
3-8 2
00_VSX-53TX.book Page 82 Monday, April 7, 2003 11:07 PM