Pioneer Elite VSX-53TX - Manual (Page 14)

Easy Setup Guide Part 2
14
8 Select AUTO SETTING with the 
buttons and press ENTER.
9 Some auto setup instructions will be
listed, make sure to follow them.
Make sure you have: hooked up the microphone and
moved obstacles to the speakers out of the way. If you
have a subwoofer make sure it is turned on and has the
volume turned up.
WARNING: The test tones are very loud!! Make sure
there are no infants or small children in the room and
that no one who will be scared, upset or injured by loud
noise is present. You yourself may want to wear earplugs.
It is possible to lower the volume of test tones, but this
could result in incorrect speaker settings.
10 If you have followed all setup
instructions and warnings above make
sure that the arrow is pointed to
START and press ENTER. Be prepared
for loud test tones.
Try to be as quiet as possible after hitting ENTER. The
test tones may take up to 30 seconds.
The volume automatically increases to 0 dB, then the
system will output some test tones and establish ambi-
ent noise levels, the microphone status, and what speak-
ers you hooked up.
11 Check the speaker settings on the OSD.
If they match your speaker configuration make sure OK
is selected and press ENTER. The test tones will be out-
put loudly again. The test tones may take up to 5 minutes
this time.
After they have finished, you see the SPEAKER SYS-
TEMS CHECK screen. If you want to view the settings
select NEXT and press ENTER repeatedly. If not, simply
go to step 13.
If they do not match the speaker configuration you
hooked up and you want to try again select RETRY with
 buttons and press ENTER. Follow the instructions
above from step 10.
If you get an error message instructing you to do some-
thing, follow the instructions and RETRY with
 but-
tons and press ENTER.
If the speaker settings do not match the speaker configu-
ration you connected and you want to input the settings
manually select ERR
FIX SP with the  buttons,
press ENTER. Go to step 12.
If you see an ERR message in the right side column,
there may be a problem with the speaker connection. If
selecting RETRY doesn't fix the problem, turn off the
power and check the speaker connections.
Speaker Distance
8
10
11
04.Easy_Setup_Guide_2.fm Page 14 Thursday, April 10, 2003 10:15 PM