Panasonic AJ-LT85P - Manual (Page 12)

u IN button (for both VTR1 and VTR2)
Press this button while holding down the ENTRY button
to register the IN point of the player or recorder.
Press it alone to check the IN point. While it is held down,
the IN point appears on the display. To display the editing
duration, press the IN and OUT buttons together.
“– –:– –:– –:– –” is displayed when the edit IN and OUT
points are not registered.
i OUT button (for both VTR1 and VTR2)
Press this button while holding down the ENTRY button
to register the OUT point of the player or recorder.
Press it alone to check the OUT point. While it is held
down, the OUT point appears on the display. To display
the editing duration, press the OUT and IN buttons
together.
o PREVIEW/REVIEW button
PREVIEW: To conduct an editing rehearsal, press this
button and light up its lamp.
REVIEW (SHIFT+PREVIEW): When reviewing the edited
block, press this button and light up its lamp.
!0 AUTO EDIT/MULTI button
AUTO EDIT: To start automatic editing, press this button
and light up its lamp.
MULT (SHIFT+AUTO EDIT): Press these buttons to edit
two or more events in succession from the current edit in
the EDL mode. Editing is executed automatically until
either the editing of the last event is completed or the ALL
STOP button is pressed to forcibly terminate the editing.
!1 ALL STOP button
When this button is pressed during preview, automatic
editing or review, the ongoing operation is stopped.
However, only VTR2 is stopped when the OPERATION
MODE switch has been set to “SEPARATE.”
When the button is pressed together with the CLEAR but-
ton, all the events in the EDL are deleted, and the event
number is set to “n01.”
!2
Event number display
Up to 100 (01 to 99, 00) edit data are controlled inside the
laptop.
Two-digit event numbers appear on this display.
Depending on the edit status, “n” or “d” appears in front of
the event number.
n: A new event which is not registered in the EDL.
d: An event which was deleted from the EDL.
No display: An event which is registered in the EDL.
FULL: All 100 events have been registered.
–: When the laptop is operated by remote control or
when the OPERATION MODE switch has been set to
“SEPARATE.”
rSt: When the power was turned on or when resetting
was performed.
CONTROLS AND THEIR FUNCTIONS
12
-
- - -
-
- -
-
- -
-
- -
-
- -
-
- -
-
- -
-
-
-
EJECT
V T R 1
POWER
REC
CH1
RESET
REC
DIAG
REMOTE
EXT VTR
LOCAL-
VTR1 VTR2
CONTROL
ON
OFF
REC
INHIBIT
OFF ON
CH2
PB
AUDIO LEVEL
REW FF
STOP STB OFF TRACK
PLAY STILL
1ST EDIT
BS EVENT
SPLIT
ASMBL
IN OUT
VTR1 VTR2 VTR1 VTR2
PREROLL
SYNCHRO
7
5
3
CF
ON
OFF
CH1
MIX
CH2
V1
V1•2
V2
SWAP
NORM
MIX
AUDIO
MONITOR
SPEAKER/
HEADPHONES
AUDIO
SWAP
DUMP LOAD EDL
CLEAR FS
RECALL
LAST
EDIT
V A1 A2 TC
PLAY
IN OUT
GO TO
ENTRY / SHIFT
EDIT MODE
COUNTER
CTL
TC
UB
VTR1
EJECT
V T R 2
RESET
REC
STORE
STOP STB OFF
MENU
EDIT
STILL REW FF
VTR2
REC
CH1 CH2
OPERATION MODE VTR2 AUDIO
INPUT SELECT EDIT
INT
EXT
SEPARATE CH1 CH2
VTR1
EXT
PB
AUDIO LEVEL
PREVIEW
REVIEW MULTI
AUTO EDIT ALL STOP
w
9 0 q
7 8