Panasonic AJ-LT85P - Manual (Page 6)

[2] Counter display section
q “Cassette loaded” display
This lights when a cassette has been loaded.
It flashes when STANDBY OFF mode is activated.
w INPUT and SCH lamps
These light when the SCH signal is input from an external
source and SCH is in alignment.
• Only INPUT lights when the SCH signal is input and
SCH is not in alignment.
e
REF and SCH lamps
These light when the reference signal is input to the REF
IN connector and SCH is in alignment.
• Only REF lights when the reference signal is input to the
REF IN connector and SCH is not in alignment.
r EDIT REC/REC/REC INH lamps
EDIT REC: This lights when the VTR is in edit recording
mode.
REC: This lights when the VTR is in recording mode.
REC INH: This lights when the VTR is in recording inhibit
mode.
t CF lamp
This lights when the color frame is locked.
y
SERVO lamp
This lights when the servo is locked.
u DV lamp
This lights when a cassette recorded using a consumer-
use DV machine has been loaded.
i W lamp
This lights when the 16:9 wide screen mode has been
set.
o
TC lamp
This lights when the time code data is displayed.
!0 UB lamp
This lights when the user bit is displayed.
!1 CTL lamp
This lights when when control signal (CTL) is displayed.
!2
DF lamp
This lights in drop frame mode.
!33 TOTAL lamp
This lights when the total editing time is displayed.
!4 REMAIN lamp
This lights when the remaining tape is displayed.
!5 Operation modes
!6 Time counter display
!7 Audio level meters
• When the EXT CHECK button is pressed, the meter is
set to the fine mode, the mark is placed at the refer-
ence level (–20 dB), and each scale unit represents a 1
dB increment. The REC level can be adjusted by sup-
plying reference level audio signals from an external
source.
• When a blank tape or blank part of a tape is played
back, fast forwarded or rewound, the meter is set to the
tape position display mode so that the current tape trav-
el position can be ascertained.
CONTROLS AND THEIR FUNCTIONS
6
INPUT
REF SCH
INH EDIT REC
SCH CF DV TC UB CTL DF TOTAL REMAIN
CH 1
CH 2
W SERVO dB –30 – –20 –16 –12 –8 –4 0
1 2 3 5 6 7 8 9 0 q w e r
u y t 4
: Appears during playback at 1 or more times
normal tape speed.
: Appears during fast forwarding operations.
: Appears during playback at –1 normal tape
speed.
: Appears during playback in the reverse direction at
–1 to 0 times normal tape speed.
: Appears during playback in the reverse direction at
–1 or more times normal tape speed.
: Appears during rewinding operations.
: Appears during in the pause/still mode
Hours
A period appears here
in the drop frame mode.
A colon appears here
in the non-drop frame mode.
All the colons are cleared when the user bit is displayed.
When nothing appears here,
the time code cannot be read
(no display either).
Minutes Seconds Frames
: Appears during normal playback or recording.
: Appears during playback at 0 to 1 normal tape
speed.
CH 1
CH 2
The tape is now traveling past a position which is
36% of the entire length of the tape from its beginning.
10's digit in percentage figure ...3
1's digit in percentage figure ...6
(Example)