Panasonic AJ-LT85P - Manual (Page 28)

EDIT
Item Setting
Description of setting
No. Item No. Item
307 SYNCHRO 0000 OFF
EDIT 0001 ON
™
308 SYNCHRO 0000 VTR1
0001 VTR2 ™
309 EDL AUTO 0000 OFF
CLR 0001 ON
™
310 AFTER 0000 STOP
CUE-UP 0001 STILL
™
311 SPLIT EDIT 0000 VIDEO
0001 AUDIO
™
312 1ST EDIT 0000 26s
DUR 0001 T-END
™
313 1ST
EDIT
™
The underlined number and item are the factory settings.
DETAILED DESCRIPTION OF SET-UP MENUS
28
This sets whether to suspend editing when phase synchronization is not pos-
sible with a ±0 frame accuracy while SYNCHRO is set to ON.
0: Phase synchronization is not suspended.
1: Phase synchronization is suspended.
This selects the deck to be phase-synchronized.
0: VTR1 is phase-synchronized.
1: VTR2 is phase-synchronized.
This sets whether the first edit is to be cleared and the subsequent edits can
be overwritten when the maximum number of edits have been registered.
0: Edits cannot be overwritten.
1: Edits can be overwritten.
This selects the laptop’s mode upon completion of a cue-up operation.
0: STOP mode
1: Still picture (SHTL+0.0, JOG STILL) mode
This sets the split editing reference.
0: The audio edit point is split with the video edit point serving as the reference.
1: The video edit point is split with the audio edit point serving as the reference.
This sets the black burst signal recording duration in the 1ST EDIT mode.
0: A black burst signal is recorded for 26 seconds, then the tape is rewound
for 3 seconds and stops.
The point at which the tape stops is set as the 1ST EDIT PRESET.
1: A black burst signal is recorded until the end of the tape or until the ALL
STOP button is pressed. If the signal is recorded until the end of the tape,
the tape is then rewound automatically to the 1ST EDIT PRESET position.
This sets the preset value in the first edit mode.
00:00:00:00 to 23:59:59:29
V V
T T
R R
1 2