Panasonic AJ-LT85P - Manual (Page 50)

EVENT EDITING
50
Registering events
Events are registered in sequence from event No.01 to 99, 00.
How to register events
• Auto editing
Press the AUTO EDIT button.
After editing has been executed, the numbers are automatically incremented by 1.
• Registering an event without executing editing
Press the STORE (SHIFT+REC) buttons.
The event numbers are incremented by 1.
When an unregistered event number (displayed as “n”) is registered:
The next event number is displayed.
• When an event number is accessed and the edit data is revised, the data which has been revised is registered in the event
number concerned.
• When an event is accessed and editing is executed without further ado, the event number remains unchanged.
When “00” appears as the event number:
This signifies the one hundredth event.
The overwrite mode (all clear) or overwrite prohibited mode is established depending on the EDL auto clear setting (set-up item
No.309 “EDL AUTO CLR”).
• When EDL AUTO CLR is OFF
The overwrite prohibited mode is established.
“FULL” appears instead of the event number. When any function button is pressed, the event number is returned to “00” and
the status which results when the edit data for event No.00 is accessed is established.
• When EDL AUTO CLR is ON
The overwrite mode is established.
The event number appears as “n00,” and the registered edit data is cleared. A new event can now be registered.
-
- - -
-
- -
-
- -
-
- -
-
- -
-
- -
-
- -
-
-
-
EJECT
V T R 1
POWER
REC
CH1
RESET
REC
DIAG
REMOTE
EXT VTR
LOCAL-
VTR1 VTR2
CONTROL
ON OFF
REC INHIBIT OFF ON
CH2
PB AUDIO LEVEL
REW FF
STOP STB OFF TRACK
PLAY STILL
1ST EDIT
BS EVENT
SPLIT
ASMBL
IN OUT
VTR1 VTR2 VTR1 VTR2
PREROLL
SYNCHRO
7 5 3
CF ON OFF
CH1 MIX CH2
V1 V1•2 V2
SWAP NORM MIX
AUDIO MONITOR SPEAKER/ HEADPHONES AUDIO SWAP
DUMP LOAD EDL
CLEAR FS
RECALL
LAST EDIT
V A1 A2 TC
PLAY
IN OUT GO TO
ENTRY / SHIFT
EDIT MODE
COUNTER
CTL TC
UB
VTR1
EJECT
V T R 2
RESET
REC
STORE
STOP STB OFF
MENU
EDIT
STILL REW FF
VTR2
REC
CH1 CH2
OPERATION MODE VTR2 AUDIO
INPUT SELECT EDIT INT EXT
SEPARATE CH1 CH2
VTR1
EXT
PB
AUDIO LEVEL
PREVIEW
REVIEW MULTI
AUTO EDIT ALL STOP
*When event editing is performed in the CTL mode,
the error may accumulate causing the edit points to
deviate considerably. It is therefore recommended
that event editing be performed in the TC mode.