Paradyne 8510 - Manual (Page 115)

5. Diagnostics and Troubleshooting
8000-A2-GB26-50 April 2001 5-19
Client Cannot Reach Router
Table 5-7, IPC-to-Router Segment , examines the IPC-to-Router segment of the
network on the IPC end of the segment.
Table 5-7. IPC-to-Router Segment
Layer Solution
Layer 1 –
Physical 1. On the IPC, make sure the cables are firmly attached to the WAN
interface.
2. If no CSU/DSUs are being used, either the router or the IPC must provide
network clocking. Network clocking is usually provided by the device
connected to the DCE cables.
3. If no CDU/DSUs exist between IPC and Router, make sure transmission
lines are active by looking for appropriate LEDs.
4. If there is no connection between the router and IPC, invert the clocking
on one or both DSU/CSUs.
Layer 2 –
Network On the IPC:
1. Set payload scramble to false. To turn PLScramble on or off on the IPC,
type map slot/port (where slot/port is that of the ATM card) and set 10=1
to false.
2. If using SONET, make sure that the line characteristics are correct. Type
map slot/port and select the Phy Media option.
3. Enter vas to make sure a service is configured.
4. Make sure encapsulation is the same as on the router (RFC1483).
5. Enter vvc to make sure vpi and vci are configured correctly.
6. Enter vcs to view ATM connection statistics.
7. Enter vcrs and vcts to view transmitted and received cells.
99-16175-01
OI
Next Hop
Router
(NHR)
DSLAM Clients
NMS
WAN
Hub SN
SN ISP
IPC
WAN
IPC-to-Router
Segment
NMS
ISP
Gateway
Router