Paradyne 8510 - Manual (Page 40)

3. DSL Card Configuration
3-4 April 2001 8000-A2-GB26-50
Minimum Configuration When Using the DSL Router
When using the DSL Router as the SN, the DSL Router is in control of the
connection. At a minimum, you must configure the following:
T VNIDs on a DSL card (see Configuring VNID(s) on a DSL Card on page 3-20)
T Activate the VNID Binding Table to the port (see Configuring the Active VNID
and the Next Hop Router on each DSL Port/Interface on page 3-22), except
when using a DSL card with an ATM Network interface in Standard mode.
NOTE:
The default minimum configuration for a DSL card with an ATM Network
interface is a valid configuration.
DSL Configuration Card Screens
Use the system information submenu of the Card screens to configure basic DSL
card-level information.
NOTES:
— Only a user who logs in to the Hotwire DSL system with Administrator
permission can configure the DSL card.
— You cannot upload a configuration from a 4-port MVL card, then download
it to an 8312 12-port ReachDSL/MVL card.