Pioneer VSX-27TX - Manual (Page 35)

35
SET UP
OPERA
TION
OPERA
TION
Playing Sources with Stereo Sound
The following instructions show you how to play audio or audio-visual stereo sources with the VSX-27TX/26TX/24TX.
2
3
4
6
STANDBY
indicator
6
3
4
2
S0URCE
DVD/LD TV/SAT VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO DSP
THX
/dts
MUTE
TV
VOLUME
MD/
TAPE1 TUNER TVCONT
RECEIVER
MULTI
OPERATION
CLASS MPX DIRECT ACCESS
CHANNEL
STATION
DTV ON/OFF DTV MENU
TUNING
EXIT
DISC
GUIDE
+10
TV CONTROL
FUNCTION
ADVANCED
MIDNIGHT
STANDARD
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
REMOTE
SETUP
DIGITAL NR
EFFECT
/CH SEL
SYSTEM
SETUP
SIGNAL
SELECT
BAND
SYSTEM
OFF
1 2 3
4 5 6
7 8 9
0 ENTER
Î
¶ 8 7 3
1 ¡ 4 ¢
+ -
+ -
+ -
MULTI CONTROL
1
Turn on the power of the playback component.
2
Press the RECEIVER button to turn on the
receiver.
Be sure that the standby indicator turns off on
the front panel.
3
Press MULTI CONTROL buttons or the FUNCTION
button to select the source you want to playback.
The FUNCTION button cycles through the sources in the
following order:
4
Press SIGNAL SELECT on the remote control or
SIGNAL SELECT on the front panel to select the
input signal corresponding to the source
component.
(See “Switching ANALOG/DIGITAL signal input” on p. 40.)
5
Start playback of the component you selected in
step 1.
6
Adjust the volume by using the volume buttons on
the remote control or the MASTER VOLUME on the
front panel.
VSX-27TX
memo If you are not able to get sound from the receiver the
problem may well lie with the SIGNAL SELECT switch. You
need to make sure the input is set to the appropriate
ANALOG or DIGITAL setting. Refer to page 40 for more on
this.
TUNER MD/TAPE 1
VCR 1 VCR 2
TV/SAT DVD/LD
VIDEO
CD
PHONO
3
Basic Playback