Pioneer DVR-660H-S - Manual (Page 110)

The Initial Setup menu 16
110
En
Tuner
Auto Channel
Setting
(Taiwan and
Philippines model) Antenna • Select if you receive channels from an antenna. It takes a few
moments for the auto tuning to complete.
Cable Select if you receive channels via cable. It takes a few
moments for the auto tuning to complete.
Auto Channel
Setting
(Other) Next Screen Proceed to the next screen, select your country, then wait for
automatic tuning to complete. The channel mapping screen
should appear when the recorder is set up. Press ENTER to
exit this screen.
Manual CH
Setting Next Screen Proceed to the next screen if you need to adjust any of the
settings made by auto tuning. Select your country, then
proceed to the manual channel setting screen:
• Change channel presets using the CHANNEL +/– buttons.
• To skip the displayed channel (because there is no station
assigned to that channel), change the Skip setting to On.
• Set the CH SYSTEM setting to match the channel system
of your country or region (except Taiwan and Philippines
model).
• Set the CHANNEL setting to the channel you want to
assign to the current channel preset (except Taiwan and
Philippines model).
• To manually fine tune the channel, change the AFT setting
to Off then adjust the Level setting.
• Set the Sound System setting to match the sound system
of your region (except Taiwan and Philippines model).
• The Name field allows you to input a name of up to five
characters for the current channel preset (except Taiwan and
Philippines model).
Channel
Swapping
(except Taiwan and
Philippines model) Next Screen Proceed to the next screen to swap channel assignments of
different presets so that you can group together presets that
naturally go together. Select two presets to swap then press
ENTER.
Video In/Out
Input Colour
System Next Screen Proceed to the next screen to set the input colour system for
the external input and the built-in TV tuner. Use the
CHANNEL +/– buttons to change the preset. On the default
Auto setting the recorder can generally correctly detect
whether the input signal is PAL, SECAM, 3.58 NTSC or PAL-
60, but in some cases you may have to set it manually if the
picture is displayed incorrectly.
See also About the input colour system on page 120 for more information on this setting.
Setting Options Explanation
DVR660HS_TLT_EN.book 110 ページ ２００８年２月２０日 水曜日 午前１１時３３分