Pioneer DVR-660H-S - Manual (Page 42)

Recording 05
42
En
• If there is very little free space left on the
HDD, an Auto Replace Recording may
not complete successfully.
• If the HDD is being used for playback or
high-speed copying when an Auto
Replace Recording is due to start, the
new timer recording will not replace the
old one. However, the next time the timer
recording starts, both of the older two
programmes will be erased.
Editing a timer programme
You can change any of the settings in a timer
programme before the recording is due to
start.
1 Press TIMER REC.
2 Highlight the timer programme you
want to change.
3 Press  then select ‘Modify’ from the
command menu panel.
Alternatively, press ENTER.
The Timer Programme Set screen appears
from which you can edit the settings.
4 Edit the timer recording settings as
necessary.
5 Select ‘Store Programme’ to finish.
Confirm the settings you made from the
following screen.
Deleting a timer programme
You can delete timer programmes you no
longer need.
1 Press TIMER REC.
2 Highlight the timer programme you
want to erase.
3 Press  then select ‘Erase’ from the
command menu panel.
• Select Yes to confirm or No to cancel.
• You can also just press CLEAR when the
timer programme is highlighted.
Skipping a regular timer
programme
If you’ve set a regular daily or weekly timer
programme, you can set the recorder to skip
the next scheduled recording.
1 Press TIMER REC.
2 Highlight the timer programme you
want to skip.
3 Press  then select ‘Cancel Once’
from the command menu panel.
• In the timer programme list, Cancel
Once appears by the programme.
• You can also just press  PAUSE when
the timer programme is highlighted.
Extending a timer recording in
progress
You can extend a timer recording beyond the
programmed end time in two different ways.
This can be useful if a broadcast programme
overruns, for example.
Cancelling or extending the timer
1 Press and hold for three seconds
during a timer recording.
Recording continues, but the timer indicator
disappears from the front panel display
indicating that the timer has been cancelled.
2 Press repeatedly to extend
recording in 30 minute blocks.
Programming a new end time
You can edit the end time of a timer
recording you have previously set.
1 Press TIMER REC.
2 Highlight the timer recording
you want to change.
3 Press
 then select ‘Modify’
from the command menu panel.
Alternatively, press ENTER.
REC
REC
ENTER
DVR660HS_TLT_EN.book 42 ページ ２００８年２月２０日 水曜日 午前１１時３３分