Pioneer DVR-660H-S - Manual (Page 117)

The Initial Setup menu
117
En
16
HDMI Output (only available when an HDMI device is connected)
Screen
Resolution 1920 x 1080p Constant 1920 x 1080p output.
1920 x 1080i Constant 1920 x 1080i output.
1280 x 720p Constant 1280 x 720p output.
720 x 576p
(720 x 480p) Constant 720 x 576p output (when setting the Input Line
System to 525 System, video is output in 720 x 480p).
720 x 576i
(720 x 480i) Constant 720 x 576i output (when setting the Input Line
System to 525 System, video is output in 720 x 480i).
• Depending on the connected device some settings may not be available.
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case,
press
 OPEN/CLOSE while holding down the  (Stop) button on the front panel to switch the setting (this also
switches Component Video Out on page 111 to the default setting).
• If you have the
Colour set to YCbCr 4:2:2, you cannot select 720 x 576i (720 x 480i).
4:3 Video Output Full Select if your HDMI TV allows you to change the aspect ratio.
Normal Select if your HDMI TV does not allow you to change the
aspect ratio. 4:3 video will be shown with bars on each side.
Colour RGB (0–255) Use if colours are weak and black appears to ‘float’ on the
RGB (16–235) setting.
RGB (16–235) Use this setting if colours appear overly rich and the black
too deep on the RGB (0–255) setting.
YCbCr 4:2:2 The video signal is output as a YCbCr 4:2:2 component
signal. This is the standard setting for HDMI-compatible
devices.
YCbCr 4:4:4 The video signal is output as a YCbCr 4:4:4 component
signal.
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the
YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
• You cannot choose YCbCr 4:2:2 when the Screen Resolution is set to 720 x 576i (720 x 480i).
Audio Output Auto • Dolby Digital, MPEG and DTS sources are output as a
bitstream signal. However, depending on the Audio Out
setting, number of audio channels, and the HDMI-connected
device, Linear PCM audio may be output.
PCM All audio signals are converted to Linear PCM (except DTS).
Bitstream
Priority Select if the connected device is compatible with bitstream
audio.
This setting is not available when a DVI device is connected.
Setting Options Explanation
DVR660HS_TLT_EN.book 117 ページ ２００８年２月２０日 水曜日 午前１１時３３分